Milan Technology MiLAN MIL-S800 User Manual download pdf (Page 7)

Chapter 2 Hardware Installation

2-1 Quick Installation

• The MIL-S800 should be placed in a well-ventilated room with proper temperature and humidity.

• Do not place the unit near water.

• The maximum distance between the port to the standard network interface is 100 meters.

• For desktop installation, ensure the surface is clean, smooth, level and sturdy. Apply self-adhesive rubber

feet to the bottom of the switch near the corners.

• For wall installation, place two screws securely into the wall. Slide the cross recesses on the bottom of the

MIL-S800 onto the screws.

• For mounting the MIL-S800 on a metal surface, install magnets as shown in instructions and apply to

surface.

• Visually check that the power cord is not damaged. Plug the female end of the cord into the rear of the

MIL-S800 and the male end (power converter) into a power outlet.

• Do not plug a phone jack connector into any RJ-45 port. This may cause damage. Use only twisted-pair

cables with RJ-45 connectors that conform to FCC standards.

Figure 4. Installation of switch

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Milan Technology MiLAN MIL-S800 User Manual Page 7