Milan Technology MIL-SM2401MAF User Manual Page 3
- Page / 178
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
FCC Warning
This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CE Mark Warning
This is a class A product. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
- User Guide 1
- FCC Warning 3
- Contents 4
- Introduction 9
- Software Features 10
- Package Contents 14
- Hardware Description 15
- LED indicators 16
- Rear Panel 18
- Desktop Installation 18
- Rack-mounted Installation 18
- Power On 19
- Network Application 20
- Segment workgroup 21
- DC Power Input 22
- Power Redundant 24
- Power Redundant Application 25
- Console Management 26
- CLI Management 27
- Commands Set List 29
- Port Commands Set 32
- Trunk Commands Set 36
- VLAN Commands Set 38
- Spanning Tree Commands Set 43
- QOS Commands Set 47
- IGMP Commands Set 50
- SNMP Commands Set 54
- Port Mirroring Commands Set 55
- 802.1x Commands Set 56
- TFTP Commands Set 60
- UPS Commands Set 61
- POE Commands Set 61
- System log Commands Set 63
- SNTP Commands Set 64
- Menu Management 65
- Main menu line interface 66
- Status and Counters 67
- Port Counters 68
- System Information 69
- System Information interface 70
- Switch Configuration 71
- Device Information interface 73
- IP Configuration interface 74
- SNTP Configuration Interface 77
- Port Configuration 78
- Trunk Configuration 79
- Port Mirroring Configuration 80
- Port Mirroring interface 81
- VLAN Configuration 82
- VLAN Configure interface 83
- Group Sorted Mode interface 88
- Priority Configuration 89
- MAC Address Configuration 90
- Misc Configuration interface 95
- STP Configuration 96
- STP Configuration interface 97
- STP Setup interface 97
- You can 98
- Per Port Setting interface 99
- SNMP Configuration interface 100
- Add Trap Manager interface 103
- LACP Configuration interface 104
- IGMP/GVRP Configuration 106
- 802.1x Configuration 107
- 802.1x Setup interface 109
- System Reset Configuration 113
- Power Menu 114
- POE Menu 116
- Save Configuration 119
- Xmodem Upgrade 120
- Web-Based Management 122
- System Login 123
- Port status 123
- View the Port Information 124
- Port Statistics 125
- Administrator 126
- IP Address 127
- Switch Setting 127
- Advanced 128
- Misc Configuration 131
- Console Port Information 132
- Port Controls 132
- Port Control interface 133
- Trunking 134
- Aggregator Information 135
- Aggregator State Activity 136
- Forwarding and Filtering 137
- IGMP Snooping interface 138
- Static MAC Address 139
- VLAN configuration 140
- VLAN – PortBase interface 142
- VLAN—PortBase Add interface 143
- 802.1Q VLAN 144
- 802.1q VLAN interface 145
- 802.1q VLAN –Add interface 146
- 6. Click 147
- Spanning Tree 149
- System Configuration 150
- Per Port Configuration 151
- Port Mirroring 152
- SNMP Management 154
- SNMP Management interface 155
- Security Manager 156
- SNTP Configuration 157
- 802.1X Configuration 157
- Per port Configuration 158
- System Log 160
- TFTP Update Firmware 162
- Configuration Backup 162
- TFTP Restore Configuration 163
- TFTP Backup Configuration 163
- Factory Default 164
- System Reboot 164
- Power Status 165
- POE Status 166
- POE Status Interface 167
- Troubleshooting 169
- Diagnosing LED Indicators 170
- Diagnosing POE problems 170
- Technical Specification 173
- Appendix 176
- Cable specification table 177
Related products and manuals for Network switches Milan Technology MIL-SM2401MAF
(12 pages)© 2020, manymanuals.com. All rights reserved. | 2.852 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals