Milan Technology MIL-SM2401MAF User Manual download pdf (Page 94)

4. Press “ESC” to go back action menu line

5. Select <Apply> to apply all configure value.

 Delete Filtering MAC address

1. Press <Delete> to delete a Filtering MAC address.

2. Choose the MAC address that you want to delete and then press “Enter”.

Misc Configuration

You can configure the switch parameters.

 MAC Address Ageing Time: MAC address table refresh time setting. Type the

number of seconds that an inactive MAC address remains in the switch’s address

table. The valid range is 0, 300~765 seconds. Default is 300 seconds.

 Broadcast Storm Filter mode: configure the broadcast storm filter mode. The valid

threshold values are 5%, 10%, 15%, 20%, 25%, and N/A. The port will be block

cause of broadcast packet is over the percentage of traffic.

 Max Bridge Transmit Delay Bound: Limit the packets queuing time in switch. If

enable, the packets queued exceed will be drop. Press Space key to set the time.

This valid value are 1sec, 2sec, 4sec and off. Default is off.

 Low Queue Delay Bound: Limit the low priority packets queuing time in switch. If

enable, the low priority packet stays in switch exceed Low Queue Max Delay Time, it

will be sent. Press Space key to enable or disable this function.

 Low Queue Max Delay Time: To set the time that low priority packets queuing in

switch. Default Max Delay Time is 255ms. The valid range is 1~255 ms.

[Note]: Make sure of “Max bridge transit delay bound control” is enabled before

enable Low Queue Delay Bound, because Low Queue Delay Bound must be work

under “Max bridge transit delay bound control” is enabled situation.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 177 178

No comments

Milan Technology MIL-SM2401MAF User Manual Page 94